For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B1325 03 : Device Power 1 Circuit Voltage Below ThresholdDTC B1325 07: Device Power 1 Circuit Voltage Above Threshold
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | B1325 03 | B1325 03 | -- | -- |
Ground | -- | B1325 03 | -- | -- |
Circuit/System Description
The following control modules monitor the system voltage through the battery positive (B+) voltage circuits:
| • | Body Control Module (BCM) |
| • | Inflatable restraint sensing and diagnostic module (SDM) |
| • | Instrument panel cluster (IPC) |
| • | Radio |
Conditions for Running the DTC
| • | The voltages supplied to the control modules are in the range of 7-26 volts. |
| • | The ignition is ON. |
Conditions for Setting the DTC
B1325 03
The control module detects a system voltage less than 9 volts 5 seconds.
B1325 07
The control module detects a system voltage greater than 18 volts for 5 seconds.
Action Taken When the DTC Sets
| • | The control module immediately disables all outputs when an out of range voltage condition has been detected, with the exception of serial data and Run/Crank relay that are disabled after a 3 minute delay. |
| • | The setting of other DTCs is inhibited. |
Conditions for Clearing the DTC
The DTC passes when the malfunction is no longer present.
Diagnostic Aids
| • | A high or low voltage value in multiple modules indicates a concern in the charging system. |
| • | Overcharging with a battery charger or jump starting can cause this DTC to set. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Charging System Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
- Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6 and 15.0 volts.
- Ignition OFF, disconnect the harness connectors of the appropriate control module.
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute.
- Test for less than 5.0 ohms between the ground circuit and ground.
- Ignition ON, verify a test lamp illuminates between the B+ circuit and ground.
- If all circuits test normal, replace the appropriate control module.
| ⇒ | If the battery voltage is not within the specified range, refer to Charging System Test |
| • | Terminal 61 X1- Terminal E12 X4 (BCM) |
| • | Terminal 31 (SDM) |
| • | Terminal 15 (IPC) |
| • | Terminal 8 X2 Radio |
| ⇒ | If greater than the specified range, test the ground circuit for an open/high resistance. |
| • | Terminals D1-D12 X3 (BCM) |
| • | Terminals 1-33 (SDM) |
| • | Terminals 11-13 (IPC) |
| • | Terminal 1 X2 Radio |
| ⇒ | If the test lamp did not illuminate , test the B+ circuit for a short to ground or an open/high resistance. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for the appropriate control module replacement, setup, and programming
