Removal Procedure
- Record the preset radio stations.
- Turn the ignition OFF.
- Disconnect the negative battery cable.
- Raise the vehicle.
- Disconnect the crankshaft position (CKP) sensor harness connector.
- Remove the attachment bolt and the CKP sensor.
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
Installation Procedure
- Lubricate the O-ring with clean engine oil.
- Install the CKP sensor in the engine block.
- Install the CKP sensor attachment bolt.
- Connect the CKP sensor harness connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.
- Connect the negative battery cable.
- Reset the clock and the preset radio stations.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the crankshaft position sensor bolt to 9 N·m (80 lb in).
