For 1990-2009 cars only
- Measure the distance between the front machined face of the cylinder block and the inboard edge of the belt on the flat side at specific locations given.
- Dimension from the front face of the cylinder block-to-edge of belt:
- If the belt to cylinder block clearance does not fall within tolerance:
- Inspect each pulley radial and axial runout at belt grooves with a dial indicator:
Tolerance:
The tolerance is 28-31 mm (1.102-1.220 in).
Important: The right front tire and splash shield will require removal.
| • | Ensure that the belt is properly located in the pulley grooves on each pulley. |
| • | Inspect the accessory drive belt for edge wear and replace if necessary. |
| • | Inspect the accessory drive pulleys for being bent or damaged. |
| • | Inspect the accessory components for proper shaft and bearing end play. Ensure all pulley hubs are properly installed on their shafts. |
Tolerance:
The tolerance is (Radial/Axial) 0.38 mm (0.015 in).
