GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2002 🢒 SL 🢒 Engine 🢒 Engine Controls - 1.9L 🢒 Electronic Brake Control Module Replacement

Removal Procedure

    Object Number: 869617 Size: SH
  1. Remove the air cleaner housing cover and the air induction hose at the throttle body.

    2. Object Number: 865817 Size: SH
  2. Remove the powertrain control module (PCM) bolts.
  3. Disconnect the PCM I/P harness electrical connector.
  4. Lift the PCM from the carrier and set aside.

    5. Object Number: 866340 Size: SH

    Important: Clean all exterior surfaces with brake cleaner.

  5. Disconnect the control module electrical connector by pulling on the lock tab.

    6. Object Number: 866344 Size: SH
  6. Remove the control module screws.
  7. Pull the control module straight off of the valve assembly.

Installation Procedure

    Object Number: 866340 Size: SH
  1. Align coils on the electronic brake and traction control module with valve cores on the brake pressure modulator valve assembly and push together.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install and tighten the screws.

    3. Tighten
    Tighten the control module-to-valve assembly screws to 4-6 N·m (35-53 lb in).

  3. Connect the electrical connector and push in the tab to lock.

    4. Object Number: 865817 Size: SH
  4. Install the PCM to the carrier.
  5. Connect the PCM I/P harness electrical connector.
  6. Install and tighten the PCM attachment bolts.

    7. Tighten
    Tighten the PCM attachment bolts to 6 N·m (53 lb in).

  7. Install the air cleaner housing cover and the air induction hose.