Removal Procedure
Caution: Refer to Vehicle Lifting Caution in the Preface section.
- Position the vehicle on the lift and raise the vehicle.
- Disconnect the electrical connector from the speed sensor and remove the
sensor.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Inspect the O-ring for damage and replace if necessary.
- Clean and lubricate the fastener with Saturn Transaxle Fluid. Wipe off
the excess fluid and install.
- Install the speed sensor.
Tighten
Tighten the vehicle speed sensor to 26 N·m (19 lb ft).
- Connect the electrical connector to the speed sensor. Push in until a
click is heard and pull back to confirm the positive engagement.
- Lower the vehicle.
- Check the transaxle fluid level. Refer to
Transmission Fluid Check
.