Removal Procedure
- Power
the sunroof to the vent position.
- Remove the 6 screws attaching the sunroof glass to the module,
and remove the glass.
Installation Procedure
- Set the glass in position on the sunroof module.
- Apply Loctite Small Screw Threadlocker 222®, or equivalent, to the
sunroof glass attaching screws and install.
- With the sunroof in the closed position, adjust the glass to 1 mm
(0.040 in) below the surface of the roof at the front, and 1 mm (0.040 in)
above the roof surface at the rear.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the bolts.
Tighten
Tighten the sunroof glass-to-sunroof bolts to 3 N·m
(27 lb in).