GM Service Manual Online
For 1990-2009 cars only

Front Bumper Fascia Replacement Sedan/Wagon

Removal Procedure


    Object Number: 867286  Size: SH
  1. Remove the push retainers from the front of the front wheelhouse panel.

  2. Object Number: 867369  Size: SH
  3. Remove the lower front and the middle front plastic retainers.
  4. Remove the upper front plastic retainers.

  5. Object Number: 867391  Size: SH
  6. Slide the front fascia forward.
  7. Disconnect the side marker lamp sockets from the lamp housings.
  8. Remove the front fascia.

Installation Procedure


    Object Number: 867280  Size: SH
  1. If installing a new fascia, transfer the side marker lamps, fascia brackets, fog-lamp grilles (if SL2 or SW2 is not equipped with fog lamps) and the emblem.

  2. Object Number: 867369  Size: SH
  3. Install the front fascia assembly to the vehicle by positioning the fascia over the front bumper fascia energy absorber.
  4. Install the side marker lamp sockets to the lamp housings.

  5. Object Number: 867391  Size: SH
  6. Install the fascia ends over the shoulder bolts extending down from the front fender upper support bracket assembly. The holes in the fascia are slotted to allow for installation without removing the shoulder bolts. The front fascia lower support plate should be on the lower side of the fascia.

  7. Object Number: 867286  Size: SH
  8. Install the retainers, the front fascia to the front wheelhouse panel.
  9. Install the upper front plastic retainers.
  10. Install the lower front and the middle front plastic retainers.

Front Bumper Fascia Replacement Coupe

Removal Procedure


    Object Number: 866801  Size: SH
  1. Remove the retainers from the wheelhouse to the fascia.
  2. Remove the side marker lamps from the fascia and disconnect the wiring.

  3. Object Number: 866329  Size: SH
  4. Remove the upper and lower retainers from the fascia.
  5. Slide the fascia forward to remove.

Installation Procedure


    Object Number: 866376  Size: SH
  1. If installing a new fascia, transfer the side marker push nuts, fascia brackets, retainer nuts and the emblem.
  2. Position the fascia on the front energy absorber.

  3. Object Number: 866795  Size: SH
  4. Feed the side marker wiring harness through each opening.
  5. Install the fascia ends over the shoulder bolts extending down from fender upper support bracket assembly. The holes in fascia are slotted to allow for installation without retaining the bolts.

  6. Object Number: 866329  Size: SH
  7. Connect the wiring harness to the front side marker lamps and install the front side marker lamps to the fascia.

  8. Object Number: 866801  Size: SH
  9. Install the retainers from the wheelhouse to the fascia.