GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2002 🢒 SL1/SC1 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - MP6/MP7 🢒 Output Speed Sensor Replacement

Removal Procedure

    Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.


    Object Number: 862911 Size: SH
  1. Position the vehicle on the hoist and ensure the ignition is OFF.

    2. Notice: Refer to Vehicle Lifting Caution in the Preface section.

  2. Raise the vehicle.
  3. Disconnect the output speed sensor (OSS) harness connector and remove the sensor.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.

    Important: 

       • Inspect the O-ring for damage and replace if necessary.
       • Clean and lubricate the fastener with Saturn Transaxle Fluid. Wipe off excess fluid.

  1. Install the OSS.

    2. Tighten
    Tighten the output speed sensor (OSS) to 26 N·m (19 lb ft).

  2. Connect the OSS harness connector. Push in the connector until a click is heard and pull back to confirm a positive engagement.
  3. Lower the vehicle.
  4. Check the transaxle fluid level.