GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2002 🢒 SL1/SC1 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - MP6/MP7 🢒 Output Shaft Assemble

    Object Number: 890231 Size: SH

    Important: Lube the O-rings with Saturn Transaxle Fluid.

  1. Install the two O-ring seals for the 4th clutch hub onto the output shaft.
  2. Use emery cloth (or equivalent) to gently remove any nicks that may be present on 4th clutch housing to prevent seal form being damaged when installed.

    3. Important: To verify repair and installation of 4th clutch seals, air check the input shaft.

  3. Lube the clutch housing inner diameter and install the 4th clutch assembly.

    4. Important: Due to the high helix performance 4th gearset, it is necessary to install the 4th driven clutch spacer in all performance (MP7) transaxles. However, the 4th driven clutch spacer may also be used in base transmissions.

  4. Install the 4th driven gear clutch spacer.
  5. Install the 4th driven gear thrust washer.
  6. Install and lube the 4th driven gear thrust bearing.

    7. Important: The 4th driven gear thrust bearing looks very similar to the 2nd/Reverse gear thrust bearing. However, the 2nd gear thrust bearing is slightly larger than the 4th gear thrust bearing. Also, the rollers on the 4th gear thrust bearing are centered between the inner and outer edges of the thrust bearing while the rollers on the 2nd gear thrust bearing are located closer to the outside edge.

  7. Install the 4th driven gear needle bearing and lube the bearing.

    8. Object Number: 864344 Size: SH
  8. Install the 4th gear and hub assembly. While installing into the clutch pack, rotate the gear and hub assembly back and forth to align the clutch plates. If you are not sure that all the clutch plates have been engaged, lift the gear out of the clutch housing and verify that all clutch tangs are aligned.
  9. Install and lube the 3rd/4th gear thrust bearing.
  10. Install the 3rd driven gear split thrust washer.
  11. Install the 3rd driven gear.
  12. Install the 2nd/3rd driven gear spacer.
  13. Install the 2nd driven gear thrust washer.
  14. Use a heat gun to heat the 2nd driven gear bearing race and install.
  15. Install the 2nd driven gear.

    16. Object Number: 864887 Size: SH
  16. Install the forward/reverse dog clutch hub with the wide end of slots, indicated by the arrow, toward 2nd gear and the oil groove on facing, indicated by the circle, towards the reverse gear.
  17. Install the forward/reverse dog clutch sleeve with the groove on the outside of the sleeve toward the reverse gear.
  18. Use a heat gun to heat the reverse driven gear bearing race and install.
  19. Install and lube the reverse driven gear needle bearing.
  20. Install the reverse driven gear.
  21. Install the reverse driven gear thrust washer.

    22. Object Number: 864734 Size: SH
  22. Assemble the sprag clutch assembly if disassembled. If disassembled, the plastic retainer sprag clutch must be discarded and replaced with a new one.
    23. 22.1. Assemble the sprag clutch into the 1st driven gear.
    22.2. Install the 1st gear bearing into the 1st driven gear hub and install the hub into the 1st driven gear.
    22.3. When viewing the 1st driven gear assembly from the sprag clutch opening side, and holding the 1st driven hub stationary, the 1st driven gear must rotate freely in the clockwise direction and lock in the counterclockwise direction.