GM Service Manual Online
For 1990-2009 cars only

Body Side Center Molding Replacement 1st Design

Removal Procedure


    Object Number: 868761  Size: SH
  1. Remove the seat belt rocker anchor Torx ® fastener.

  2. Object Number: 868781  Size: SH
  3. Slide the seat belt webbing through the slit on the shoulder belt guide.

  4. Object Number: 868577  Size: SH
  5. Remove the seat belt retractor cover by pulling on it.
  6. Route the seat belt retractor cover down the seat belt webbing.

Installation Procedure


    Object Number: 868781  Size: SH
  1. Route the seat belt webbing through the seat belt retractor cover.
  2. Install the seat belt retractor cover.
  3. Slide the seat belt webbing through the slit on the shoulder belt guide.
  4. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 868761  Size: SH

    Caution: Apply Loctite 242® Threadlocker US P/N 12345382 (Canadian P/N 10953489), or equivalent, on all restraint bolts/nuts before installation. Failure to use such threadlocker correctly may result in personal injury.

  5. Install the seat belt rocker anchor and Torx® fastener.
  6. Tighten
    Tighten the shoulder belt lower attachment fastener to 50 N·m (37 lb ft).