High Mount Stop Lamp Replacement Coupe

1. Remove the center high-mount stop lamp cover. Pull down by grasping the cover around the edges.
2. Disconnect the electrical harness only if removing the center high-mount stop lamp.
3. If removing the bulbs, twist the sockets out of the stop lamp and remove the bulbs.
4. Remove the center high-mount stop lamp by removing the retainer screws.

1. Install the center high-mount stop lamp with the screws.
2. Connect the electrical harness.



3. Install the cover by placing the tabs in the slots, then firmly press the cover into place.

High Mount Stop Lamp Replacement Wagon

1. Open the lift gate.
2. Remove the plastic fasteners to the upper garnish molding by pushing the center of the fastener in.
3. Remove the molding.
4. If removing the bulbs, twist the sockets out of the stop lamp and remove the bulbs.
5. Disconnect the electrical harness.
6. Remove the center high mount stop lamp by removing the retainer screws.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the center high mount stop lamp with the screws.

Tighten
Tighten the center high-mount stop lamp (Sedan/Wagon) to 2.5 N·m (19 lb in).

2. Connect the electrical harness.
3. Install the upper garnish molding with the plastic fasteners.
4. Close the lift gate.

High Mount Stop Lamp Replacement Sedan

Notice: Do not pull on edges of center high-mount stop lamp cover. Damage to cover may result. Slide fingers between cover and lamp and pull down carefully.

1. Remove the center high-mount stop lamp cover.
2. Disconnect the electrical harness only if removing the center high-mount stop lamp.
3. If removing bulbs, twist the sockets out of the stop lamp and remove the bulbs.
4. Remove the center high-mount stop lamp by removing the retainer screws.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the center high-mount stop lamp with the screws.

Tighten
Tighten the center high-mount stop lamp (Sedan/Wagon) to 2.5 N·m (19 lb in).

2. Connect the electrical harness.
3. Install the cover by placing the tabs in the slots, then gently press the cover into place.