Removal Procedure
- Remove the endcap assembly.
- Disconnect the door jamb switch from the wiring harness.
- Compress the plastic tabs (to body of switch) and push the switch from
inside of the end-cap.
Installation Procedure
- Insert the door
jamb switch in the end-cap until the tabs lock.
- Connect the wire harness to the door jamb switch.
Notice: Refer to Fastener Notice in the Preface section.
- Install the end-cap assembly.
Tighten
Tighten the endcap-to-I/P fasteners to 2.2 N·m (19 lb in).