- Apply RTV sealer GM P/N 12345739 or equivalent to the rear bearing
retainer sealing surfaces.
- Install the rear bearing retainer bolts to the rear case.
Tighten
Tighten the bolts to 41 N·m (30 lb ft).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the four-wheel drive indicator switch to the front case
half.
Tighten
Tighten the switch to 27 N·m (20 lb ft).
- Install the speed sensor and the bolt to the rear bearing retainer.
Tighten
Tighten the bolt to 16 N·m (12 lb ft).
- Install the following
components to the rear output shaft:
| 5.1. | The rear output yoke |
| 5.2. | The rubber sealing washer |
| 5.4. | The rear output yoke nut |
Tighten
Tighten the nut to 170 N·m (125 lb ft).
- Install the following components to the front output shaft:
| 6.1. | The front output yoke |
| 6.2. | The rubber sealing washer |
| 6.4. | The front output yoke nut |
Tighten
Tighten the nuts to 224 N·m (165 lb ft).
