For 1990-2009 cars only
- Turn the steering wheel so that the vehicle's wheels are pointed straight ahead.
- Turn the ignition switch to the LOCK position and remove the key.
- Connect the left and right curtain inflator module (YEL 2-way) connectors.
- Install the instrument panel upper trim panel.
- Connect the passenger (YEL 2-way) connector.
- Attach the connector clip to the metal brace near the HVAC fan.
- Connect the driver (YEL 2-way) connector and clip to the steering column brace.
- Install the AIR BAG fuse in IPFB.
- Turn the ignition ON and verify the AIR BAG telltale operates properly.
Notice: Be careful not to damage the VIN plate when removing or replacing the upper trim panel.
Important: Be sure the upper trim panel seal is correctly seated on the forward edge before installing the upper trim panel.
Important: LHD illustration shown, RHD similar.
| 4.1. | Ensure the hook-and-loop fastener attachments on the upper trim panel are correctly inserted. |
| 4.2. | Position the upper trim panel on the retainer assembly. |
| 4.3. | Align the tabs on the sides the of upper trim panel with the openings in the windshield garnish molding. |
| 4.4. | Align the clips with the clip locations. |
| 4.5. | Firmly snap in the clips at the clip locations. |
Notice: Refer to Fastener Notice in the Preface section.
| 4.6. | Install the screws on underside of upper trim panel on passenger side of vehicle. |
Tighten
Tighten the upper I/P trim panel fasteners to 6 N·m (53 lb in)
Important: LHD illustration shown, RHD similar.
