For 1990-2009 cars only
- Remove the sealer.
- Remove the back glass, interior trim, and rear speakers. Drill spot welds from the panel assembly-quarter inner rear and the gutter assembly-rear compartment side.
- Clean all of the weld seams with a wire brush, prime, and seal all repair areas.
- Apply a permanent underbody sealant.
- Prime with a 2-part catalyzed primer.
- Apply sealers and corrosion protection materials according to the information in the Body Paint section of this service manual or the paint manufacturer's recommendations.
- Clean the surface for welding and grind the primer off of the new part at the connecting points. Apply 3M® Weld-Thru Coating P/N 05913, or equivalent, to all areas to be welded.
- Measure and align the panel assembly rear seat. Clamp into place.
- Use a MIG to plug the weld.
Important: Ensure that proper corrosion protection processes are used on all repair areas.
