Important: Do not apply an excessive amount of sealer to an area. An excessive amount of sealer will take longer to dry and could come in contact with body parts or components within the immediate area of the body repair.
After welding any body parts, the areas must be wire brushed and cleaned. When this is done, prime the area with DP90LF Epoxy Primer, mixed with DP401LF Catalyst (or equivalent) before applying the recommended sealer. This will not only waterproof the weld seam, but prevent exhaust gases from entering the passenger compartment. For proper sealing locations, refer to the following illustrations:
Shock Tower
Front Body Hinge Pillar Outer 3/4 Section
Front Body Hinge Pillar Outer 3/4 Section
Front Body Hinge Pillar Outer 3/4 Section
Front Body Hinge Pillar Inner
Rocker Panel Inner
Rear Side Door Ring
Rear Side Door Ring
Rear Side Door Ring
Back Body Pillar - Outer Lower - Wagon
Quarter Rear
Rear Compartment Side
Back Body Pillar - Outer Lower - Wagon
Rear Compartment Side
Quarter Rear
Rear Compartment Side
Quarter Inner Rear
Rear Compartment Rear
Rear Compartment Rear
Windshield Outer
Rear End
Rear Compartment Rear
Rear Compartment Longitudinal
Rear End
Panel - Rocker Inner
B-Pillar
