For 1990-2009 cars only
Removal Procedure
- Remove the rear seat cushion from the vehicle. Refer to Rear Seat Cushion Replacement .
- Cut the hog rings attaching the outer perimeter of the seat pad/cover unit to the seat cushion frame.
- Cut the hog rings at the seat belt pass through locations.
- Remove the rear seat cushion pad/cover unit from the seat cushion frame.
- Remove the cloth covered listing wire from the old seat cushion pad/cover unit.
Important: SC1/SL/SL1/SW1 have a rear seat cushion cover that has an integral pad. The cover and pad cannot be serviced separately. The rear cushion frame is serviced separately.
Installation Procedure
- Transfer the cloth covered listing wire from the old seat cushion pad/cover unit to the new pad/cover unit.
- Center the seat pad/cover unit over the seat cushion frame. Align allof the listing wires with the attaching locations of the frame.
- Beginning at the center of the cover, hog ring the pad/cover unit listing wires to the seat frame at all of the same hog ring locations that attached the original cover.
- Push the seat belt buckle pass through the flaps and through the cushion pad.
- Hog ring the pass through the cover material to the seat frame at the same locations that attached the original cover.
- Check the fit of the pad/cover unit and pull on the cover where necessary to remove any wrinkles.
- Install the rear seat cushion to the vehicle. Refer to Rear Seat Cushion Replacement .
