Security System Sensor Data Circuit Low
Circuit Description
The passlock sensor data is supplied to the body control module (BCM) by circuit
1836.
The passlock sensor data supplied to the BCM is in the form of V-codes or voltage
codes. When the proper ignition key is turned in the ignition switch, the correct
V-code is supplied to the BCM. The BCM responds by sending a serial data password
to the powertrain control module (PCM) allowing the engine to run.
Conditions for Setting the DTC
| • | Ignition is in RUN, CRANK |
| • | Circuit 1836 shorted to ground |
| • | Turns on service wrench telltale and security telltale |
Diagnostic Aids
| • | Check for poor connection at the BCM. Inspect the harness connectors for
backed out terminals, improper terminal mating, broken connector locks, improperly
formed or damaged terminals and poor terminal-to-wire connection (terminal crimped
over wire insulation and not conductors). |
| • | Inspect the wiring harness for damage. Check for broken or chafed insulation. |
| • | Check for poor connection at the passlock sensor. |
| • | If the fault is suspected to be intermittent, wiggling harness
wiring may help in locating fault. |
