DTC P0731. Saturn SL2/SC2/SW2 2001

For 1990-2009 cars only

Makes 🢒 Saturn 🢒 2001 🢒 SL2/SC2/SW2 🢒 DTC 🢒 DTC P0731

Circuit Description

The powertrain control module (PCM) uses the crankshaft position (CKP) sensor, input speed sensor (ISS) and output speed sensor (OSS) to determine engine speed, input shaft speed and output shaft speed. These sensor readings are used to determine the current gear ratio and RPM slip across the torque converter. The PCM uses this information from the sensors to determine if the commanded gear matches the actual gear. During normal driving conditions, the PCM will adapt main line pressure via the pressure control (PC) solenoid to prevent slipping and harsh shifts. First gear clutch is fed fluid directly from the manual valve and is applied in all forward gears. DTC P0731 sets when 1^st clutch still slips after the PCM has commanded high main line pressure.

DTC Parameters

DTC P0731 will set if the PCM detects an incorrect actual 1^st gear ratio when 1^st gear is commanded ON when:

•	The condition exists for longer than 3 seconds (2001)*

•	The condition exists for longer than 3 seconds, 1 minute is allowed to elapse, then condition again exists for longer than 3 seconds.

•	A high main line pressure has been commanded

•	The transaxle is in a forward gear

•	The input speed is greater than 224 RPM.

•	The vehicle speed is greater than 5 km/h (3 mph)

•	The speed noise parameter = NO

•	The steady state ratio fail counter equals 255 for an in-gear failure, or the shift fail counter is greater than 100 on a downshift to 1^st during acceleration

•	128=0 or normal operation

•	The condition exists twice in one ignition cycle

•	The second gear must be commanded ON for the vehicle to move.

Diagnostic Aids

Important: If DTC P0745, P0746, P0756, P0758, P0761, P0763, P0766, P0768, or P0789 is set, diagnose that DTC first. A diagnosed PC solenoid, shift solenoid 2, 3 or 4 low/high circuit fault DTC may have caused DTC P0731 to set.

Important: If any shift solenoid performance DTCs P0781, P0782, or P0783 (2^nd , 3^rd or 4^th gear stuck On) are set, diagnose the highest gear first. A gear stuck On will cause no 1^st gear.

If DTCs P0745, P0746, P0756, P0758, P0761, P0763, P0766, P0768, or P0789 is set, diagnose that DTC first. A diagnosed PC solenoid, shift solenoid 2, 3 or 4 low/high circuit fault DTC may have caused DTC P0731 to set.

Possible causes of no 1^st gear ratio:

•	The end cover first gear hub seal rings damaged

•	1^st clutch piston leaking

•	The input shaft feed tube to end cover blocked

•	The servo leaking or passages blocked causing no oil pressure to 1^st clutch

•	1^st gear sprag failed

•	1^st gear clutch plates worn

Verify TRANSMISSION ISS and TRANSMISSION OSS read correctly on Scan tool.

Make sure the pressure control, shift 2, shift 3 and shift 4 solenoids are not intermittently sticking. Sticking solenoids may cause 2^nd , 3^rd or 4^th gear to be applied from an initial start causing no 1^st gear. Audible sound should be similar for all solenoids. A muffled tone indicates the need for replacement.

Important: 1^st gear is a mechanical hydraulic apply. Other than line pressure, there is no electrical circuit for 1^st gear.