For 1990-2009 cars only
- Install the engine oil cooler and the new O-ring seals.
- Apply a 2 mm (0.08 in) bead of P/N 12378521, or equivalent, in the groove around the engine oil cooler cover.
- Install the engine oil cooler cover bolts using the torque sequence shown.
- Install the engine oil cooler inlet and the outlet nuts.
- Install the oil feed line to the engine block.
- Install the return line to the engine block.
- Install the engine oil cooler line clamp
- Install the crank sensor.
- Install the crank sensor bolt.
- Install the oil filter assembly.
- Install the oil feed and install the return lines to the engine oil cooler. Use the 4 new seals.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the engine oil cooler cover bolts to 30 N·m (22 lb ft).
Tighten
Tighten the engine oil cooler inlet and the outlet nuts to 20 N·m
(15 lb ft).
Tighten
Tighten the oil cooler feed and the return lines to the engine block
to 30 N·m (22 lb ft).
Tighten
Tighten the oil cooler feed and the return lines to the engine block
to 30 N·m (22 lb ft).
Tighten
Tighten the crankshaft position sensor bolt to 8 N·m (71 lb ft).
Tighten
Tighten the oil filter cartridge housing-to-engine to 45 N·m
(33 lb ft).
Tighten
Tighten the oil cooler feed and the return lines to the engine block
to 30 N·m (22 lb ft).
