Tools Required

J 39194-C Oxygen Sensor Wrench

Important: Bank 1 are cylinders 1, 3, 5 which are closest to the front of the dash.

1. Turn ignition OFF.
2. Disconnect heated oxygen sensor 1 harness connector.

Notice: Removal of the sensor is easier if the exhaust system is slightly warmed up. Be careful that the exhaust is not hot to work on safely. Moving the sensor back and forth while applying penetrating oil to the threads will aid in removal and will decrease the chance of exhaust pipe thread damage.

3. Use liquid penetrate before removing sensor.
4. Remove heated oxygen sensor 1 using the J 39194-C .

1. Apply a small amount of anti-seize compound Saturn P/N 21485279 (or equivalent) to threads of the heated oxygen sensor 1.

Notice: Refer to Fastener Notice in the Preface section.

2. Install heated oxygen sensor 1 using the J 39194-C (or equivalent).

Tighten
Tighten HO2S-1 (sensor-to-exhaust pipe) to 45 N·m (33 lb ft).

3. Connect heated oxygen sensor 1 harness connector. Make sure locking tab is in the full closed position.
4. Start engine and make sure no exhaust leaks exist.