- Apply automatic transmission
fluid to a new transmission wiring connector O-ring seal (46).
- Install the new transmission wiring connector O-ring seal (46)
onto the transmission wiring harness assembly (33).
- Install the transmission wiring harness assembly (33) into
the transmission case assembly through the wiring harness bore.
- Apply automatic transmission
fluid to the new transmission fluid temperature sensor O-ring seal (32).
- Install the new transmission fluid temperature sensor O-ring
seal (32) into the groove of the transmission fluid temperature sensor (36).
- Install the transmission fluid temperature sensor (36)
into the front control valve body fluid temperature sensor bore.
- Install the transmission fluid temperature sensor clip (49).
- Install the 1 - M6 x 1.0 x 50 mm
fluid temperature sensor bolt (31).
Tighten
Tighten the fluid temperature sensor bolt to 7.8-11.8 N·m
(69.0-104.5 lb in).
Important: Do not bend or damage the solenoid wire connector pins.
- Connect the 8 solenoid wire connectors as follows:
