| Subject: | Service Information Regarding OnStar®Communication and Interface Module
(CIM) Programming |
| Models: | 2002 L-Series vehicles equipped with OnStar®(RPO UE1) |
| 2002 VUE vehicles equipped with OnStar®(RPO UE1) |
Purpose
The purpose of this bulletin is to provide the procedure for programming a new
OnStar®communication and interface module (CIM). The procedure in this bulletin
should be performed whenever a new CIM is being installed in a 2002 L-Series or 2002
VUE vehicle.
Communication And Interface Module (CIM) Programming Procedure:
- After installing a new communication and interface module (CIM), perform
the "Setup New OnStar" procedure found in the "OnStar Special Functions" menu of the
scan tool.
| 1.1. | Select vehicle (Saturn LS, Saturn LW, or Saturn SUV). |
| 1.2. | Select "Set-up OnStar" to configure module. When configuration is complete,
scan tool will display "Download Completed." |
Important: The station ID (STID) number and electronic serial number (ESN) can be accessed
using the scan tool ("OnStar Module Information 2" menu). The vehicle identification
number (VIN) cannot be accessed using the scan tool. It must be recorded off of the
vehicle.
- Record the station ID (STID) number and electronic serial number (ESN) from
the CIM, and the vehicle identification number (VIN).
Important: Do not contact the OnStar®Call Center until step 1.2 has been completed.
- Contact the OnStar®Call Center and provide them with the STID number, ESN
and VIN. OnStar®will then complete the configuration of the new CIM.
