GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2003 🢒 VUE - AWD 🢒 Body and Accessories 🢒 Wipers/Washer Systems 🢒 Windshield Washer Solvent Container and Pump Replacement

Removal Procedure

    Object Number: 931356 Size: SH

    Important: Allow the coolant surge tank sufficient cooling time before handling.

  1. Remove the coolant surge tank bolts.

    2. Important: Do not disconnect the coolant hoses from the coolant surge tank.

  2. Disconnect the surge tank level sensor and set surge tank aside in engine compartment.
  3. Remove the front washer solvent container bolts.

    4. Object Number: 929316 Size: SH
  4. Disconnect the front washer solvent container hose from the front washer nozzle hose that runs along the upper motor compartment rail.
  5. Angle the washer solvent container to the rear of the vehicle and pull out of the mounting hole.
  6. Disconnect the washer pump electrical connector.

    7. Important: Contain any solvent the may spill while removing pump and hoses.

  7. Pull the washer solvent pump from the solvent container.
  8. Disconnect the front and rear washer solvent hoses from the washer pump.

Installation Procedure

    Important: Do not reuse washer solvent as debris may clog the system.


    Object Number: 929316 Size: SH
  1. Connect the front and rear washer solvent hoses to the washer pump.
  2. Install the washer pump into the washer solvent container. Ensure the washer pump filter is installed, if removed.
  3. Connect the washer pump electrical connector.
  4. Insert the front and rear washer solvent container hoses into the grooves in the solvent container.

    5. Important: Washer solvent container grommet must be installed between container and body structure to prevent squeaks and rattles.

  5. Install the washer solvent container into the motor compartment. Ensure that the washer solvent container's mounting peg, with grommet installed, is seated into the mounting hole in the body structure. A lubricant may be used to ease installation.
  6. Connect the front washer solvent container hose to front nozzle hose that runs along the upper motor compartment rail.

    7. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 931356 Size: SH
  7. Install the washer solvent container screws.

    8. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  8. Position coolant surge tank back into correct location.
  9. Install the coolant surge tank bolts.

    10. Tighten
    Tighten the bolts to 6 N·m (53 lb in).

  10. Fill the washer solvent container with washer solvent.