Circuit Description
During Battery Saver Mode, the engine control module (ECM) determines if the throttle plate is returning to the correct de-energized position. If the ECM determines the throttle plate is not at the correct position during Battery Saver Mode, this DTC is set.
Conditions for Running the DTC
| • | The ignition is ON and the engine is OFF. |
| • | The ignition voltage is more than 8.5 volts. |
| • | The Battery Saver Mode is active. |
Conditions for Setting the DTC
The ECM detects that the throttle plate is not at the correct position during Battery Saver Mode.
Action Taken When the DTC Sets
The PCM stores conditions which were present when the DTC set as Failure Records only. This information will not be stored as Freeze Frame Records.
Conditions for Clearing the MIL/DTC
| • | The DTC becomes history when the conditions for setting the DTC are no longer present. |
| • | The history DTC clears after 40 malfunction free warm-up cycles. |
| • | The PCM receives a clear code command from the scan tool. |
Diagnostic Aids
Inspect for mechanical conditions or binding that may be temperature related. Components may not move freely in extreme heat or cold due to the presence of contaminants or ice formation.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Engine Control Module Connector End Views | ||||
1 | Did you perform the Diagnostic System Check-Engine Controls? | -- | Go to Step 2 | |
2 | Are DTCs P1120 and P1220 also set? | -- | Go to Step 3 | |
3 |
Does the scan tool indicate that the throttle position is within the specified values? | 32-44% | Go to Step 6 | Go to Step 4 |
4 | Remove the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you find any obstructions preventing the throttle plate from returning to the default position? | -- | Go to Step 5 | Go to Step 6 |
5 | Remove the obstruction. Did you complete the action? | -- | Go to Step 7 | -- |
6 | Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
7 |
Did the DTC fail this ignition? | -- | Go to Step 2 | Go to Step 8 |
Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? | -- | System OK | ||
