For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Rotate the steering wheel until one of the triangular openings is accessable with a small flat-bladed tool.
- Insert the small flat-bladed tool into the triangular opening to release the steering wheel inflatable restraint module from the steering wheel.
- Rotate the steering wheel 180 degrees and insert the small flat-bladed tool into the triangular opening to release the steering wheel inflatable restraint module from the steering wheel.
- Disconnect the horn switch and the inflatable restraint electrical connectors.
- Remove the inflatable restraint steering wheel module.
Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.
Caution: Refer to SIR Caution in the Preface section.
Caution: A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
Installation Procedure
- Connect the horn switch connector.
- Connect the inflatable restraint connectors.
- Align the retaining pins on the inflatable restraint module with the steering wheel.
- Push the inflatable restraint module to secure.
- Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
- After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping for proper disposal.
Important: This vehicle is equipped with dual stage air bags, you will find 2 connectors. Match the right color connector to the right color opening in the module.
