- Remove the lift gate applique. Refer to
Liftgate Applique Replacement
in Body Rear End.
- Remove the rear wiper arm. Refer to
Rear Window Wiper Arm Replacement
in Wiper/Washer Systems.
- Remove the lift gate trim panel. Refer to
Liftgate Trim Panel Replacement
in Body Rear End.
- Remove the rear wiper module. Refer to
Liftgate Wiper Motor Replacement
in Wiper/Washer Systems.
Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Notice: Care must be taken to avoid damaging paint around glass during removal.
- Remove the electrical connectors from the rear window defogger bus bars. Position
the electrical connectors so not to damage the wiring/connectors when using the urethane
power removal tool.
Important: Before cutting out a stationary window, apply
a double layer of masking tape around the perimeter of the painted surfaces and inner
trim.
- Apply two 15 cm (6 in) pieces of duct tape to the top and bottom
of the glass to prevent it from falling out when the urethane adhesive is cut.
Caution: When using power tools that may create smoke when cutting urethane sealant,
work should be done in a well ventilated area and/or with a NIOSH/MSHA Approved air
supplied respirator to prevent possible harmful exposure.
When the urethane adhesive is heated enough to give off smoke, high levels of
methylene diisocyanate (MDI) may be present.
Unprotected exposure to methylene diisocyanate (MDI) may result in severe, chronic,
debilitating respiratory problems.
- From the inside of the lift gate, cut the urethane around the glass using aJ 39032
.
- With the aid of an assistant, remove the lift gate window from the opening.
