Notice: Improper cruise control release switch adjustment may cause brake damage such
as brake drag, heat buildup and excessive brake lining wear.
- Disconnect the cruise brake switch harness
connector.
- Rotate the cruise brake switch counterclockwise and remove the cruise
brake switch from the switch retainer.
Important: Do not depress the brake pedal assembly during
the brake switch installation. Depressing the brake pedal will cause a brake drag
condition.
- Install the cruise brake switch.
| • | Position the switch into the retainer with the electrical connector index
notch pointing to the 1 o'clock position. |
| • | Slide the switch in the retainer until the plunger is fully depressed
into the barrel. |
| • | Rotate the switch clockwise until the travel stop has been reached, approximately
60 degrees. |
| • | Inspect the cruise brake switch to ensure the switch is properly locked
into the switch retainer with the cruise brake switch electrical connector index notch
pointing to the 3 o'clock position. |
- Connect the cruise brake switch harness connector.
- Use the scan tool to monitor CRUISE BRAKE SWITCH in the engine control
module (ECM) General Information data table, while depressing and releasing the brake
pedal. Verify the APPLIED and RELEASED states read correctly.
