GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2005 🢒 VUE - AWD 🢒 HVAC 🢒 HVAC Systems - Manual 🢒 HVAC Control Module Replacement

Removal Procedure
  1. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement.
  2. Remove the I/P storage compartment. Refer to Instrument Panel Storage Compartment Replacement.
  3. Remove the center trim bezel. Refer to Instrument Panel Accessory Bezel Replacement.

    4. Object Number: 939709 Size: SH
  4. Disconnect the temperature cable from the HVAC control module.
  5. Disconnect the blower switch from the HVAC control module.
  6. Disconnect the electrical connector from the HVAC control module.
  7. Disconnect the remaining electrical connectors from the center trim bezel.

    8. Object Number: 939703 Size: SH
  8. Remove the HVAC control module screws from the center trim bezel.
  9. Remove the HVAC control module from the center trim bezel.

Installation Procedure

    Object Number: 939703 Size: SH
  1. Install the HVAC control module to the center trim bezel.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the HVAC control module screws to the center trim bezel.

    3. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).


    Object Number: 933565 Size: SH
  3. Center the temperature cable knob by inserting the assembly alignment tab into the centering slot of the temperature knob shaft.

    4. Object Number: 933637 Size: SH
  4. Center the HVAC module temperature door by aligning the cable lug of the temperature control cable with the center point of the detent spring. Detent spring force should hold the temperature door in the desired position.

    5. Object Number: 939709 Size: SH
  5. Connect the temperature cable to the HVAC control module.
  6. Connect the blower switch to the HVAC control module.
  7. Connect the electrical connector to the HVAC control module.
  8. Connect the remaining electrical connectors to the center trim bezel.
  9. Install the center trim bezel to the I/P. Refer to Instrument Panel Accessory Bezel Replacement.
  10. Install the I/P storage compartment. Refer to Instrument Panel Storage Compartment Replacement.
  11. Install the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement.

    12. Important: Any time an HVAC module mode actuator or the HVAC control module is replaced, the HVAC control module must be calibrated to ensure proper air distribution.

  12. Calibrate the mode door by simultaneously pushing the A/C and RECIRC buttons on the HVAC control module three times each, within 2 seconds of initial push.
    13. • The A/C and RECIRC button LEDs will flash while this calibration is taking place.
    • The calibration will take anywhere between 10-30 seconds depending on battery voltage.
    • The LED's will quit flashing when the calibration is complete.
  13. Cycle the ignition and verify proper operation.
  14. Refer to Control Module References for programming and setup information.