Tools Required
J 44811
Accessory Belt Tensioner Unloader
Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- Install the
J 44811
onto the tensioner.
- Remove the accessory drive belt.
Installation Procedure
- Route the belt around the alternator and the A/C compressor.
- Install the
J 44811
onto the tensioner and unload spring tension from the tensioner while positioning the belt.
- Release the tensioner and remove the tool.
Notice: Refer to Fastener Notice in the Preface section.
- Connect the negative battery cable
Tighten
Tighten the battery terminal bolt 17 N·m (23 lb ft).