Removal Procedure
Caution: Do not strike or jolt the inflatable restraint sensing and diagnostic module
(SDM). Before applying power to the SDM, make sure that it is securely fastened with
the arrow facing toward the front of the vehicle. Failure to observe the correct
installation procedure could cause SIR deployment, personal injury, or unnecessary
SIR system repairs.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
.
- Remove the console assembly. Refer to
Front Floor Console Replacement
in Instrument Panel, Gages, and Console.
- Remove the retainers from the connector position assurance (CPA) and disconnect the electrical connectors.
- Remove the nuts and remove the sensing and diagnostic module (SDM).
Installation Procedure
- Remove any dirt, grease, or other contaminants from the mounting surface.
Notice: Refer to Fastener Notice in the Preface section.
- Install the SDM to the vehicle with the nuts.
Tighten
Tighten the nuts to 10 N·m (89 lb in).
- Install the console assembly. Refer to
Front Floor Console Replacement
in Instrument Panel, Gages, and Console.
- Enable the SIR system. Refer to
SIR Disabling and Enabling
.
Important: If you do NOT perform the body control module (BCM) programming procedure, the vehicle option content information which is read by the BCM may be incorrect and a DTC B1001 Option Configuration Error will set in both the
SDM and the BCM. This will illuminate the AIR BAG telltale.
- Reprogram the BCM. Refer to
Body Control Module (BCM) Programming/RPO Configuration
in Computer/Integrating Systems.
- Refer to
Control Module References
for programming and setup information.