Removal Procedure
- Remove the clutch master cylinder hose retainer clip.
- Disconnect the clutch master cylinder hose (1) from the transaxle.
- Remove the transaxle. Refer to
Transmission Replacement
.
- Remove the clutch actuator cylinder bolts from the transaxle.
- Remove the clutch actuator cylinder.
Installation Procedure
Important: Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.
- Lightly lubricate the inside diameter of the bearing with input shaft lubricant P/N 21005995 or equivalent.
- Install the clutch actuator cylinder (1) to the transaxle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the clutch actuator cylinder bolts.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
- Install the transaxle. Refer to
Transmission Replacement
.
- Install the clutch master cylinder hose retainer clip.
- Connect the clutch master cylinder hose (1) to the transaxle by pushing it in until it seats.
- Bleed the clutch hydraulic system. Refer to
Hydraulic Clutch Bleeding
.