Removal Procedure
- Remove the clutch pressure control solenoid cover. Refer to
A/B Clutch Pressure Control Solenoid Assembly Cover Replacement
.
- Disconnect the shift control solenoid valve electrical connectors, noting proper location.
- Remove the transmission wiring harness bolt and harness assembly.
Installation Procedure
- Apply automatic transmission fluid to a new transmission wiring connector O-ring seal.
- Install the new transmission wiring connector O-ring seal onto the transmission wiring harness assembly.
- Install the transmission wiring harness assembly into the transmission case assembly through the wiring harness bore.
Notice: Refer to Fastener Notice in the Preface section.
- Install the transmission wiring harness assembly bolt.
Tighten
Tighten the bolt to 12 N·m (106 lb in).
- Install the clutch pressure control solenoid cover. Refer to
A/B Clutch Pressure Control Solenoid Assembly Cover Replacement
.