• | J 25031-A Three Jaw Puller |
• | J 39400-A Halogen Leak Detector |
• | J 45267 Clutch Holding Tool |
• | J 45504 Clutch Pulley Installer |
• | SA9149AC-8 Snap Ring Pliers |
Important: It may be necessary to pry the switch lightly with a small screwdriver.
Important: It is important to use Saturn Sealant P/N 22681632 as a thermal conductive material. Failure to use this sealant may affect the function of the switch.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 6 N·m (53 lb in).
Important: The A/C clutch bearing and pulley is a slip fit on the compressor. If correctly aligned the pulley should slip on easily. If difficulty is encountered, install using the pulley installer tool.
Important: Align the block tooth on the disk and hub assembly with the groove in the shaft.
Measure
The clearance should be 0.35-0.75 mm (0.014-0.030 in).
Tighten
Tighten the nut to 26 N·m (19 lb ft).