Removal Procedure
- Turn the ignition OFF.
- Disconnect the manifold absolute pressure (MAP) sensor harness connector.
- Remove the MAP sensor attachment screw and remove the MAP sensor and O-ring (6).
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Make sure the MAP sensor mounting surface is clean. Install the MAP sensor with the new O-ring and attachment bolt (6).
Tighten
Tighten the manifold absolute pressure sensor screw to 4 N·m (35 lb in).
- Connect the MAP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.