Important: Follow the balance procedure steps listed below. Powertrain mounts must be tightened in sequence.

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Loosen the front transaxle mount through bolt.



3. Loosen the rear transaxle mount through bolt.
4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.

Notice: Refer to Fastener Notice in the Preface section.




5. Tighten the rear transaxle mount through bolt.

Tighten
Tighten the bolt to 100 N·m (74 lb ft).




6. Tighten the front transaxle mount through bolt.

Tighten
Tighten the bolt to 100 N·m (74 lb ft).

7. Lower the vehicle.