Removal Procedure
Important: Do not swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock, "XM Theftlock" will be displayed.
- Remove the rear seat. Refer to
Rear Seat Replacement.
- Disconnect the electrical connector.
- Remove the receiver fasteners.
- Remove the receiver from the vehicle.
Installation Procedure
- Install the receiver to the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the receiver fasteners.
Tighten
Tighten the fasteners to 3 N·m (26 lb in).
- Connect the electrical connector.
- Install the rear seat. Refer to
Rear Seat Replacement.
- Perform the setup procedure for the digital radio receiver. Refer to
Control Module References for programming and setup information.