Tools Required

1. Inspect the bearing for wear and rough rotation. If the bearing is OK, removal is not necessary.
2. Place a shaft protector (3) between transfer output shaft (913) and SA9211T-2  (1) in order to prevent damaging the shaft.
3. Using DT 46424  (1), J 22912-B  (2), and the shaft protector (3), remove the transfer case input gear with shaft front bearing (914) from the transfer case input gear assembly (913).

1. Using DT 46509 and a hydraulic press, install the transfer case input gear with shaft 22 x 76 x 19 mm front bearing (914) onto the transfer case input gear with shaft (913). Ensure the bearing is properly seated on the shaft.
2. Inspect and adjust the transfer case input gear with shaft installed height as necessary. Refer to Transfer Case Input Gear Installed Height Measurement .