- Install an automatic transmission wiring harness O-ring seal (3) on the automatic transmission wiring harness (2)
and route the wiring harness through the transmission case housing bore.
- Connect the green wire harness connector to the B shift solenoid valve (470).
- Connect the yellow wire harness connector to the TCC solenoid valve (468).
- Connect the red wire harness connector to the A shift solenoid valve (466).
- Connect the orange wire harness connector to the C shift solenoid valve (465).
Notice: Refer to Fastener Notice in the Preface section.
- Install the transmission wiring harness assembly (2).
- Install the transmission wiring harness M6 x 1.0 x 20 mm bolt (1).
Tighten
Tighten the bolt to 12 N·m (106 lb in).