For 1990-2009 cars only
- Install a 8 x 105.8 mm clutch pressure control (CPC) solenoid fluid pipe (14) into the transmission case (31).
- Install 2 8 x 58.3 mm CPC solenoid fluid pipes (15), (19) into the transmission case (31).
- Install the new CPC solenoid gasket (20) to the clutch pressure control solenoid manifold (84).
- Install a 7.7 x 2.3 mm fluid pipe O-ring seal (9) over each of the 3 fluid passage pipes.
- Install the CPC solenoid valve assembly (18) onto the solenoid cover (84).
- Install the following CPC solenoid valve bolts:
- Tighten the bolts in the sequence shown.
Important: Install the fluid feed pipes with the filter side of the pipe into the transmission case as shown in insert.
Important: Do not damage the O-ring seals (9) during installation.
| • | 5 M6 x 1.0 x 25 mm bolts (17) |
| • | A M6 x 1.0 x 55 mm bolt (16) |
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 12 N·m (106 lb in).
