For 1990-2009 cars only
- Install a 8 x 53 mm TCC apply pressure control solenoid fluid feed passage tube (11) with the filter end facing the transmission case hole (2).
- Measure from the top of the 8 x 53 mm fluid passage tube (11) to the machined surface of the transmission case (31). This is the installed height (a) of the fluid passage tube (11).
- If the measurement between the top of the tube and the case machined surface is approximately 7 mm (0.3 in), the tube is correctly installed in the accumulator fluid passage port.
- If the measurement is greater than 7 mm (0.3 in), install the fluid passage tube again until it is correctly seated in the accumulator body.
- Install a 8 x 36 mm TCC lock-up pressure control solenoid fluid apply passage pipe (10) with the filter end facing the transmission case.
- Install the following components into the transmission case:
- Install both 7.7 x 2.3 mm clutch pressure control fluid passage pipe O-ring seals (9) over the fluid feed passage tubes.
- Install the TCC apply pressure control solenoid assembly (7).
- Install the 4 TCC pressure control solenoid valve M6 x 1.0 x 30 mm bolts (6).
| • | A 8 x 25.2 mm TCC lock-up pressure control solenoid fluid apply passage pipe (13) |
| • | A new TCC apply pressure control solenoid gasket (12) |
Important: Do not damage any of the TCC lock-up pressure control fluid passage pipe O-ring seals (9) during installation.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 12 N·m (106 lb in).
