Tools Required

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .
3. Remove the wheel driveshaft. Refer to Front Wheel Drive Shaft Replacement .



4. Use the SA9133T in order to remove the seal.
5. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.

1. Use the J 44385 and the J 7079-2 in order to install a new seal. Ensure that the seal is seated flush to the outer bore area.
2. Lubricate the seal with Dexron®-III transmission fluid Saturn P/N 21019223.
3. Install the wheel driveshaft. Refer to Front Wheel Drive Shaft Replacement .
4. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
5. Lower the vehicle.