Tools Required

J 36346 Fascia Retainer Remover

1. Using the J 36346 or equivalent, disconnect the shift cable ends from the transaxle by prying on both sides with even pressure.
2. Disconnect the shift cables from the shift cable bracket. Discard the shift cable retaining clips.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
4. Remove the wheel.
5. Remove the left inner splash shield.



6. Shift the transmission into NEUTRAL.
7. Remove the shifter guide bolt.



8. Remove the shifter retaining bolts.
9. Remove the shifter.

Important: Ensure there is not any excessive sealer around the shift rod bushing.

1. Apply sealer P/N 12378516 to the transaxle case to shifter cover mating surface.




Important: Install all possible shifter bolts with the shifter in NEUTRAL. Install the last shifter bolt with the shifter in gear, then shift back into NEUTRAL.

2. Install the shifter.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the shifter retaining bolts.

Tighten
Tighten the bolts to 25 N·m (18 lb ft).




4. Ensure the transaxle is in NEUTRAL.
5. Apply P/N 21485278 to the shifter guide bolt.

Notice: Hand start and tighten the shifter guide bolt to avoid damaging the shift lever.

6. Install the shifter guide bolt.

Tighten
Tighten the bolt to 25 N·m (18 lb ft).

7. Install the left inner splash shield.
8. Install the wheel . Refer to Tire and Wheel Removal and Installation .




Important: New cable clips must be used to ensure proper retention.

9. Connect the shift cables to the shift cable bracket.
10. Connect the shift cable ends to the transaxle.
11. Lower the vehicle.