GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Use care when working around the roof rail inflator module because sharp objects may puncture the roof rail airbag and the airbag will not deploy correctly.

    In order to avoid personal injury, if any part of the module is damaged replace the entire module

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the headliner and the garnish moldings from the vehicle. Refer to Headlining Trim Panel Replacement .
  3. Important: Remove all clips and plastic guides from the structure. Clips are designed for single usage only. The new inflator assembly will contain new clips and plastic guides.

  4. Unsnap the SIR tether retainer and remove the tether from the windshield pillar.

  5. Object Number: 964653  Size: SH
  6. Remove the SIR module fasteners from the inflator retention tabs and clips. Remove the SIR module from the vehicle.

Installation Procedure


    Object Number: 964653  Size: SH

    Important: Position the module tether rearward of the molding attaching clips.

  1. Unpack the new inflator assembly. Start at the rear of the vehicle and install the inflator module to the structure with integral T-locator and fasteners.
  2. Working from the rear of the vehicle, install the retaining tabs to the structure to hold the inflator module in place.
  3. Notice: Refer to Fastener Notice in the Preface section.

    Important: Visually inspect the side curtain to assure that the curtain is not twisted.

  4. Install the remaining side SIR module fasteners.
  5. Tighten
    Tighten the fasteners to 5 N·m (44 lb in).

  6. Install the hook on the curtain tether to the windshield pillar. Snap the hook retainer into place.
  7. Install the headliner and the garnish moldings to the vehicle. Refer to Headlining Trim Panel Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
  9. After replacing the module, deploy the old module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .