GM Service Manual Online
For 1990-2009 cars only

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P1A7B: Starter/Generator Control Module Temperature Sensor Performance

Circuit/System Description

The starter/generator control module (SGCM) monitors the temperature sensor to determine if the sensor is reading correctly, by comparing it to average of 3 other sensors after 480 minute soak.

Conditions for Running the DTC

The engine is running.

Conditions for Setting the DTC

The average (PIMTEMP 1, PIMTEMP 2, APMTEMP) - BOARDTEMP is greater than 30°C (86°F).

Action Taken When the DTC Sets

    • 50 percent maximum torque limit
    • APM 50 percent maximum current output

Conditions for Clearing the DTC

Return to normal range for 10 seconds.

Diagnostic Aids

Possible internal failure at temperature sensor

Reference Information

Schematic Reference

Hybrid Controls Schematics

Connector End View Reference

Hybrid Controls Connector End Views

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Scan Tool Data List

Circuit/System Verification

Caution: To help avoid personal injury, additional precautions must be taken prior to working on the generator control module or the generator starter. After removing the 36V battery cables from the generator battery, remove both engine wiring harness connectors from the generator control module. Wait at least 5 minutes and then remove the generator control module cover. Verify voltage levels at all 36V, 12V, and 3-phase connections, are less than 3 volts using a DMM before proceeding.

  1. If DTC is history, refer to Testing for Intermittent Conditions and Poor Connections .
  2. With ignition ON, observe the scan tool SGCM temperature sensor parameters.
  3. If only the SGCM board temperature sensor reads high, replace the SGCM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for SGCM replacement, setup, and programming