Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC C0110 04: Pump Motor Circuit OpenDTC C0110 61: Pump Motor Circuit Actuator Stuck
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
B+ | C0110 00 | C0110 00 | -- | -- |
Ground | -- | C0110 00 | -- | -- |
Circuit/System Description
The pump motor is an integral part of the brake pressure modulator valve (BPMV), while the pump motor relay is integral to the electronic brake control module (EBCM). The pump motor relay is not engaged during normal system operation. When the antilock brake system (ABS) or traction control system (TCS) operation is required the EBCM activates the pump motor relay and turns the pump motor ON.
Conditions for Running the DTC
C0110 04
| • | Ignition ON. |
| • | Initialization is complete. |
C0110 61
| • | The test is initiated once per ignition cycle, when the vehicle speed is greater than 8 km/h (5 mph), and a fault was set on the last ignition cycle. |
| • | The vehicle speed is greater than 20 km/h (13 mph), and the brake is not applied. |
| • | The vehicle speed is greater than 40 km/h (26 mph). |
Conditions for Setting the DTC
C0110 04
The EBCM detects a short to ground or an open/high resistance on the B+ circuit.
C0110 61
| • | The EBCM detects the pump motor runs continuously. |
| • | The EBCM detects the pump motor is binding or stalled. |
Action Taken When the DTC Sets
| • | The EBCM disables the ABS/ traction control system (TCS)/ vehicle stability enhancement system (VSES) for the duration of the ignition cycle. |
| • | The EBCM sends a serial data message to illuminate the appropriate warning indicator/message. |
Conditions for Clearing the DTC
| • | The condition for the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles. |
Diagnostic Aids
The pump motor is integral to the BPMV, and the pump motor relay integral to the EBCM.
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation Reference
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit Verification
Ignition ON, perform the Pump Motor Test with a scan tool and listen/feel the Pump Motor turn ON and OFF.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the EBCM.
- Test for less than 5 ohms between the ground circuit terminal 16 and ground.
- Ignition ON, verify that a test lamp illuminates between the B+ circuit terminal 1 and ground.
- If all circuits test normal, replace the EBCM. If the DTC resets, replace the BPMV.
| ⇒ | If greater than the specified range, test the ground circuit for an open/high resistance. |
| ⇒ | If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ABS motor circuit fuse is open, test or replace the BPMV. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for EBCM replacement, setup, and programming |
