Tools Required

1. Pull each end of the hood rear seal away from the cowl panel flange near both strut towers.
2. Install three J-28467-13  (1) and two J 28467-5  strut tower adapters (2) to the top of the left and right strut tower.
3. Install a 127 cm (50 in) engine support fixture cross bar J 28467-B  (3) transversely across the vehicle between both J 28467-5  strut tower adapters (2).
4. Insert safety pins J-28467-10 (4) through the J 28467-5  strut tower adapters (2) and the cross bar (3) to prevent movement.



5. Remove air conditioning line bracket (1) from cross bar beam.



6. Position two 58 cm (23 in) engine support fixture cross bars (1) longitudinally with two J 36462-A leg assembly (2).
7. Install two J 28467-1A  clamp (3) to secure the longitudinal mounted cross bar to the transverse mounted cross bar.



8. Assemble the lift hook wing nut J 28467-34 , lift hook bracket J-28467-6A and lift hook J 28467-7A to the engine lift bracket on the engine.



9. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).



10. Position the J 28467-7A  lift hook to the rear engine lift bracket.



11. Assemble the lift hook wing nut J 28467-34 and the lift hook bracket J-28467-6A to the lift hook J 28467-7A .



12. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).



13. Position the J 28467-7A  bolt hook (1) to the front engine lift bracket.



14. Evenly tighten both wing nuts J 28467-34  (1) until the engine weight is supported by the engine support fixture and no longer carried by the engine mounts.