GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Saturn 🢒 2009 🢒 VUE - AWD 🢒 Driver Information and Entertainment 🢒 Cellular, Entertainment, and Navigation 🢒 DTC P1AE8, P1AE9, P1AEA, or P1AEB

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P1AE8: Drive Motor 1 Control Module Hybrid Battery Voltage Sense Circuit Low Voltage

DTC P1AE9: Drive Motor 1 Control Module Hybrid Battery Voltage Sense Circuit High Voltage

DTC P1AEA: Drive Motor 2 Control Module Hybrid Battery Voltage Sense Circuit Low Voltage

DTC P1AEB: Drive Motor 2 Control Module Hybrid Battery Voltage Sense Circuit High Voltage

Circuit/System Description

The drive motor generator power inverter module (PIM) contains two motor control modules (MCM). Each MCM monitors its internal high voltage sensor for correct operation.

Conditions for Running the DTC
    • The ignition is ON.
    • Ignition voltage is 8-18 volts.
    • The high voltage contactor relays are closed.

Conditions for Setting the DTC

P1AE8 and P1AEA

The motor control module (MCM) detects high voltage sensor voltage less than 0V.

P1AE9 and P1AEB

The motor control module (MCM) detects high voltage sensor voltage greater than 564V.

Action Taken When the DTC Sets
    • DTCs P1AE8, P1AE9, P1AEA and P1AEB are Type B DTCs.
    • The hybrid powertrain control module (HPCM) commands the battery energy control module (BECM) to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTCs P1AE8, P1AE9, P1AEA and P1AEB are Type B DTCs.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Circuit/System Verification
  1. Clear the DTC information.
  2. Turn the ignition OFF for 1 minute.
  3. Turn the ignition ON.
  4. Retest for DTCs P1AE8, P1AE9, P1AEA and P1AEB.

Circuit/System Testing

Ignition ON, retest for DTCs P1AE8, P1AE9, P1AEA and P1AEB.

⇒If the DTC resets, program the PIM with the latest software version and recheck for DTCs. If the DTC resets after programming or if the PIM already contains the latest software version, replace the PIM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for PIM replacement, setup, and programming.