DTC P2544 Hybrid
Diagnostic Instructions
DTC Descriptor
DTC P2544 : Transmission Torque Request Circuit
Circuit/System Description
To improve shift feel, the transmission control module (TCM) may request that the engine control module (ECM) reduce engine torque during shift events. When such a request is received, the ECM responds by delaying the base ignition timing
and notifying the TCM that the request has succeeded. If the ECM is unable to comply with the request, the ECM sends the TCM a message that the request has failed.
The torque reduction request is sent to the ECM through a communication network called the controller area network (CAN). Two circuits are used to communicate CAN data between the ECM and TCM. A fault in the CAN will not cause DTC P2544 to
set by itself. If a CAN fault occurs, other DTCs will set before DTC P2544.
Conditions for Running the DTC
• | No other CAN errors are present. |
• | The engine is running for 5 seconds and not in fuel cut-off. |
Conditions for Setting the DTC
The ECM notifies the TCM that a torque reduction request has failed for 1 second.
Action Taken When the DTC Sets
• | DTC P2544 is a Type B DTC. |
• | The TCM commands maximum line pressure. |
• | The TCM freezes transmission adaptive functions. |
Conditions for Clearing the DTC
DTC P2544 is a Type B DTC.
Diagnostic Aids
It is possible for this DTC to set due to a stack-up or misalignment issue, where no electrical fault is present. Ensure the gear shift selector cable is properly adjusted and there are no service bulletins that address this concern before replacing parts.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Data Link Communications Description and Operation
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Start the engine; observe the DTC information with a scan tool. CAN DTCs should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Circuit/System Testing
- Ignition ON, attempt to establish communication with the ECM with a scan tool.
- Ignition OFF, disconnect the harness connector of the ECM.
- Ignition ON, verify that 1.5-3.4 volts is available between the CAN serial data low and the CAN serial data high circuits.
⇒ | If the voltage is not within the specified range, replace the ECM. |
- Ignition OFF, test the CAN communication circuits between the ECM and the TCM for an open, short to ground, or a short to voltage.
- If the circuits/connections test OK, replace the TCM.
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the repair.
Control Module References for TCM replacement, setup, and programming