Preliminary Procedures

1. Open the front door on the side the front and rear side door opening frame reveal molding assembly is being removed from.
2. Remove the front and rear side door opening frame reveal molding lower screw.
3. Working from front to rear, release the integral retainers securing the reveal molding to the body.

1

Front and Rear Side Door Opening Frame Reveal Molding Screw

Caution: Refer to Fastener Caution in the Preface section.

Tighten
1.5 N·m (13 lb in)

2

Front and Rear Side Door Opening Frame Reveal Molding Retainer (Qty: 19)

Tip
Inspect and replace any plastic retainers nuts that are damaged.

3

Front and Rear Side Door Opening Frame Reveal Molding Assembly

Procedure

1. Upon assembly of the front and rear side door opening frame reveal molding to the body, insert the locating boss at the rear edge of the molding to the front top side of the body, near the rear quarter window.
2. Align the retainers from the rear edge working towards the front.
3. Apply palm pressure from the rear retainer to the front retainer up to the front fender screw location.
4. Install the screw.